Induction automatic doors make the common types of doors and windows in our daily life, especially in the office space or building entrance. There are many accidents about induction doors on the network, so how to eliminate potential safety hazards and prevent failures? It's OK to install the glass sensing automatic door correctly.
1. Leveling and marking
Level gauge shall be leveled and plumb crane shall be vertical. First, the control sideline of ground rail chute shall be snapped, and then the installation center line and elevation control line of cross beam shall be snapped.
2. Installation of ground guide rail
Pry out the embedded wooden brace at the position where the track is to be installed, chisel and trim it according to the control ink line of the track chute snapped in advance, bury and install the lower track after meeting the installation requirements, and note that the total length of the lower track shall be 2 times of the width of the open door + 100mm. It should be noted that the top elevation of the lower track should be the same as the elevation of the floor surface or within 3mm lower.
3. Installation of steel beam
Automatic door steel crossbeam is generally made of channel steel of [16 - [22 Specification], both ends are welded and fixed on the embedded iron parts of reinforced concrete door posts or walls on both sides of the door opening, and the thickness of the embedded parts is usually δ = 8-10 mm.
During installation, align according to the elevation control line snapped in advance and the center position line of the steel beam, and pay special attention to check the levelness with a level ruler before symmetrical welding.
4. Chassis installation
Change the switch operation, adjust the direction and speed of the door opening.
Finally, install the sensing probe, open and install the sensor, and then adjust the probe. Pay attention to adjust the proper angle, and do not touch the antenna. The automatic door drive control box and automatic detection device are fixed on the steel beam, and the fixed connection mode includes the steel beam drilling and bolt fixing mode and the steel beam welding connecting plate re connecting and fixing mode. It should be noted that the drilling or welding of connecting plates on the steel beam should be completed before the installation of the steel beam.
5. Door leaf installation
First, check that the track is straight and smooth, and then install the sliding door leaf after the smooth part is polished by the grinder. Elastic limit material shall be installed at the end of sliding door leaf. The door leaf shall slide smoothly.
Turn on the power supply, adjust the detection angle and response sensitivity of the microwave sensor to achieve the best working condition.
What are the precautions for installing the responsive door
First, install the aluminum alloy gate crossbeam first, and keep it horizontal during installation, otherwise, the working force track will generate uneven stress after installation, and the wear will be intensified.
II. Use the door body hanging bolt assembly to install the door body, and pay attention to keep the center position of the pulley parallel to the door body.
III. install the limit device on the guide rail of the power beam, and adjust the position by adjusting the bolt of the limit device.
IV. after the installation of the door body, the height and gap position of the door body shall be adjusted, and the fixing nuts of the hanger shall be adjusted to ensure that there is no stagnation or friction sound when the door body moves.
V: adjust the belt tension, keep the belt tight when stretching, and fasten all pressing plate bolts.
VI: the upper and lower gaps of the door body shall be consistent when installing the ground wheel.
VII. If the control system fails to work smoothly, it needs to be adjusted. First, check the door body manually, and then cut
Eight: the whole door body is installed, and the power supply is connected for operation detection.
How to install the sensing door? What are the precautions for installing the sensing door
The above is how to install the sensing door and what are the precautions for installing the sensing door. Here, I'd like to make a warm reminder that we should pay more attention to some matters in daily use of the sensing door, keeping in mind "one look, two stops and three passes", so as to reduce the safety accidents caused by the sensing door.